Sondy vířivých proudů společnosti Olympus se sestávají z renomovaných obchodních značek Nortec a NDT Engineering. Nabízíme více než 10 000 standardních a na míru navržených absolutních sond vířivých proudů, referenčních standardů a příslušenství. Tato část popisuje mnoho standardních sond vířivých proudů , které jsou nabízeny v celé řadě průměrů, frekvencí a typů konektorů.
Společnost Olympus také nabízí vlastní systémy sond na bázi vířivých proudů, které splňují specifické požadavky kontrol. K dispozici je mnoho různých typů sond, které lze navrhnout tak, aby odpovídaly obrysům součásti, nebo je lze tvarovat tak, aby se vešly do upínacího přípravku, čímž dojde k urychlení a zpřesnění kontroly.
Vezměte prosím na vědomí, že dostupnost produktu se v jednotlivých regionech liší. Více informací vám poskytne místní obchodní zastoupení společnosti Olympus.
The rotating plastic scanner probes section features a variety of expandable plastic-tip probes and stainless-steel backshell probes, including the SUB series, SPO-5965 series, SPO-3564 series, and standard series.
Manual bolt hole probes have coils located at right angles to the probe direction, and are rotated by hand with the fastener removed. Standard (fractional and metric) and custom diameters are available with absolute and differential coils.
Spot probes are used for discovering flaws both on and below surfaces. Their large coil diameter and low frequency operation are advantageous for scanning larger areas, and providing an increased detectable flaw size; typically equal to one-half of the probe diameter.
Weld probes are designed to inspect ferrous welds. They provide a cost effective alternative to magnetic particle inspection, which requires the part to be prepared (cleaned) prior to inspection.
Sliding probes are specifically designed to inspect rows of fasteners. They operate in reflection mode and are used to find surface and near-surface flaws. They come in adjustable types, which are able to accommodate different fastener sizes, and fixed types, which are usually procedure specific.
90° tip, stainless-steel shaft. Designed for general surface crack detection, these probes are available in a variety of lengths, and with various coil configurations, drops, and connector options.
Straight stainless-steel shaft. Designed for general surface crack detection, these probes are available in a variety of lengths, and with various coil configurations and connector options.
30° or 45° tip, stainless-steel shaft. Designed for general surface-crack detection, these probes are available in a variety of lengths, and with various coil configurations, drops, and connector options.
Flexible copper shaft of these probes can be bent to various shapes. Designed for general surface crack detection, flexible surface probes are available in a variety of lengths, and with various coil configurations, drops, and connector options.
Bent shaft surface probes are general purpose stainless-steel probes used for surface or near-surface crack detection. They are available in a variety of sizes, and with various coil configurations and connector options.
Pencil surface probes are general purpose plastic-tip probes used for surface or near-surface crack detection. They are available with various coil configuration and connector options. Pencil surface probes feature an adjustable collar for greater stability.
The other rotating scanner probes section includes a variety of specialized scanner probes, such as the Adjustable X type series, the Adjustable Y type series, the Countersink series, and the Countersink Stainless Steel series.
Ring/Donut probes are made to fit various fastener head diameters. Their principal use is for subsurface crack detection with the fastener in place. They are available in both bridge and reflection configurations.