The new TXE probe series is the best at detecting circumferential cracks, particularly those located at the edge of supports or tube sheets. The output display is an intuitive C-scan image, and in addition, the probe can be used to scan the whole length of the tube at very high speeds.
Recommendations
TXE probes are designed to be used for the detection of circumferential cracks in stainless steel tubing.
Features
Detection of circumferential cracks anywhere in the tube, including tube-sheet and support locations.
Full-length tube inspection with speeds almost equal to the ECT standard speed (1 m/s), replacing rotation pancake probes.
2-D and 3-D C-scan representation for maximum understanding of signals using the MultiView C-scan option.
Solid and durable titanium construction.
No multiplexer required. Direct connection to the standard MS 5800 EC extended connector.
Option to use up to four frequencies with mixing, and all with C-scan displays.
Standard/Custom Probes (Made to Order)
Use the nomenclature and the chart below to configure your part number.
Probe Type
Coils Disposition
Probe Diameter
(use mm in part ID)
Frequency Level
Cable Length
mm
in.
TXE: Eddy current array tube probe
R8: 8 reflection coils
Standard
13.8 mm to 24 mm
by 0.2 mm
Standard
0.543 in. to 0.945 in.
by 0.008 in.
MF: Medium frequency optimized for stainless steel.
20 m (65 ft)
Probe Response
The TXE-series eddy current array probes have independent channels that enable generation of C-scan views for easier analysis.
CT02 ECT Olympus NDT Calibration Tube C-Scan
Circumferential cracks (75% and 50% at the support)
Sorry, this page is not available in your country
Let us know what you're looking for by filling out the form below.
